The WEILDER 5-hole wheel spacers for FORD Focus can significantly improve the road holding of your competition vehicle. They center the wheel while widening the track.
WEILDER wheel spacers are made of high quality anodized aluminum and specially adapted to each vehicle.
WEILDER 5-hole wheel spacers are available in different thicknesses: 10, 15 or 20mm.
For the assembly of these wheel spacers, we advise you to use special studs which will be longer than the original screws.
Wheel spacers are sold in pairs.
For competition use, we recommend a stud + nut combination.
Attention, for safety reasons, it is essential to respect the pitches and lengths of the threads.
Fitting wheel spacers for FORD Focus requires the use of longer studs: length of your original bolting + width of the wheel spacer.
Fasteners / bolts not supplied.
Advice before placing your order:
The compatibility of our wheel spacers is only ensured for mounting on the original rims of your vehicle.
you need to measure your center distance. The center distance is measured as follows: it is the distance between the center of one of the holes in your rim and the center of your wheel, then multiply this result by 1.701.
Assembly advice:
You need to check the centering length of your hub in order to choose the right wheel spacer thickness. Some vehicles having long centerings, the thinnest spacers cannot be mounted.
If the length of your centering is less than or equal to 11mm, you can mount 12mm thick wheel spacers, if it is less than or equal to 15mm, 16mm spacers and less than or equal to 19mm, 20mm wheel spacers.
Suitable for the following vehicles:
FORD Focus II type DA3 / DB3 (2003 > 2010)
FORD Focus III / RS type DA3-RS (09/2008 > 02/2011)
FORD Focus IV / ST type DYB ( > 2011)
