Haltech Driveshaft Split Collar 1.812" / 46mm I.D. 8 Magnet
Includes: 1 x Driveshaft Split Collar 1.812" I.D. 8 Magnet
1 x 5/32 Allen Key
Notes: 8 magnet pickup split collar - suits 1.812" / 46mm Driveshaft
Features Dimensions ID : 1.812" / 46mm OD: 3.385" / 86mm W: 0.375" / 9.54mm
Haltech Driveshaft Split Collar 1.875" / 47.63mm I.D. 8 Magnet
Includes: 1 x Driveshaft Split Collar 1.875"/ 47.63mm I.D. 8 Magnet
1 x 5/32 Allen Key
Notes: 8 magnet pickup collar - suits 1.875"/ 47.63mm Driveshaft
Features Dimensions ID : 1.875"/ 47.63mm OD: 3.385" / 86mm W: 0.375" / 9.54mm
Haltech Driveshaft Split Collar 2.125"/ 53.98mm I.D. 8 Magnet
Includes: 1 x Driveshaft Split Collar 2.125"/ 53.98mm I.D. 8 Magnet
1 x 5/32 Allen Key
Notes: 8 magnet pickup split collar - suits 2.125" / 53.98mm Driveshaft
Features Dimensions ID : 2.125"/ 53.98mm OD: 3.385" / 86mm W: 0.375" / 9.54mm
Haltech Driveshaft Split Collar 2.187" / 55.55mmI.D. 8 Magnet
Includes: 1 x Driveshaft Split Collar 2.187"\ 55.55mm I.D. 8 Magnet
Notes: 8 magnet pickup split collar - suits 2.187" Driveshaft
Features Dimensions ID : 2.187" / 55.55mm OD: 3.385" / 86mm W: 0.375" / 9.54mm
Use in conjunction with a hall effect sensor to enable measuring of driveshaft RPM. Driveshaft split collars are typically installed to the rear end yoke or coupler. The inside diameter of the split collar should match the outside diameter of the yoke or coupler to ensure proper fitment.
The collar is secured around the shaft using the two cap screws. Ensure the gaps are the same after tightening the cap screws for proper operation.
Position the sensor so it aligns with the outside centre of the collar. Set the gap according to your gap requirements.
